基于SVM的固化土无侧限抗压强度模型

为实现较少试验次数下固化土无侧限抗压强度(qu)的准确预测, 提出了基于支持向量机(SVM)的固化土qu的预测模型. 以固化剂各组分掺入比、龄期、初始含水量、固化剂掺量等因素为输入量, 固化土的qu作为输出量, 以径向基为核函数, 采用网格搜索法和交叉验证法进行参数优化, 建立了基于SVM的固化土qu的预测模型. 算例分析表明: 该模型适用于任意条件下固化土qu的精确预测, 且在较小试验成本下实现与响应面法相当的预测精度.     

Global optical model potential describing 12C-nucleus elastic scattering

We construct a new global optical model potential to describe the elastic scattering of ¹²C. The experimental data of elastic-scattering angular distributions and total reaction cross sections for targets from ²⁴Mg to ²⁰⁹Bi are considered below 200 MeV within the framework of the optical model. The results calculated using the derived global optical potential are then compared with the existing experimental data. The reliability of the global optical potential is further tested by predicting the elastic scattering data out of the mass and energy ranges, within which the global potential parameters are determined, and reasonable results are also obtained.     

秋千参数自激振动的数学模型与数值模拟

将秋千视为变长度单摆,基于归一化高斯函数构造了摆球相对摆杆的速度表达式.在此基础上建立了秋千的非线性动力学微分方程,并据此数学模型对秋千运动进行了数值模拟,得到了秋千的运动规律和功能转化的机制.     

A modified model for isothermal homogeneous and heterogeneous reactions in the boundary-layer flow of a nanofluid

The homogeneous and heterogeneous reactions in the boundary-layer of a flat surface are considered. The autocatalysts are assumed to be of regular sizes, while the solution is a dilute nanofluid. The heat release due to the chemical reactions is taken into account. The Buongiorno's model is used to describe the behaviors of this reaction system. This configuration makes the current model be different from all previous publications. Multiple solutions are given numerically to the rescaled nonlinear system, whose stability is verified. The results show that the strength coefficients of the homogeneous and heterogeneous reactions are key factors to cause the appearance of the multiple solutions in the distribution of the chemical reactions. Nanofluids enhance the diffusion of heat and help maintain the stability of chemical reactions.     

Mass spectrometry imaging of latent fingerprints using titanium oxide development powder as an existing matrix

Recent research has focused on increasing the evidentiary value of latent fingerprints through chemical analysis. Although researchers have optimized the use of organic and metal matrices for matrix‐assisted laser desorption/ionization‐mass spectrometry imaging (MALDI‐MSI) of latent fingerprints, the use of development powders as matrices has not been fully investigated. Carbon forensic powder (CFP), a common nonporous development technique, was shown to be an efficient one‐step matrix; however, a high‐resolution mass spectrometer was required in the low mass range due to carbon clusters. Titanium oxide (TiO₂) is another commonly used development powder, especially for dark nonporous surfaces. Here, forensic TiO₂ powder is utilized as a single‐step development and matrix technique for chemical imaging of latent fingerprints without the requirement of a high‐resolution mass spectrometer. All studied compounds were successfully detected when TiO₂ was used as the matrix in positive mode, although, generally, the overall ion signals were lower than the previously studied CFP. TiO₂ provided quality mass spectrometry (MS) images of endogenous and exogenous latent fingerprint compounds. The subsequent addition of traditional matrices on top of the TiO₂ powder was ineffective for universal detection of latent fingerprint compounds. Forensic TiO₂ development powder works as an efficient single‐step development and matrix technique for MALDI‐MSI analysis of latent fingerprints in positive mode and does not require a high‐resolution mass spectrometer for analysis.     

含水合物沉积物多相渗流特性研究进展

天然气水合物作为一种储量大、无污染的清洁能源近些年受到了广泛关注. 近20年来,中国进行了较大范围的陆海域天然气水合物储层勘探与储量预测.2017年,中国地质调查局牵头对南海神狐海域的天然气水合物进行了基于降压渗流原理的试验性开采.国内外已进行的水合物试采工程面临着气体产量低、出砂较多等问题,其最主要的原因之一是开发过程中沉积物内复杂多相渗流机理尚不明晰.本文综述了平行毛细管模型、Kozeny模型等广泛应用于天然气水合物开发渗流分析的理论模型,对比分析了水合物开发多尺度渗流过程模拟方法,简述了国内外含水合物沉积物渗透率测试、渗流过程中沉积物物性演变以及水合物开采室内模拟等方面的渗流实验进展,总结了矿场尺度的天然气水合物储层开采过程中产气数值模拟手段,展望了多相渗流模型、储层原位含水合物样品室内测试及结构与物性演化、矿场尺度数值模拟与水平井压裂技术等应用研究的未来方向与挑战.      

Modified Burgers-Reimschuessel model for moisture-sensitive polymers

Viscoelastic properties of moisture-sensitive polymers can be significantly affected by moisture in the ambient environment, resulting in drastic changes in the properties as the absorbed moisture content increases. In this article, a simple yet important modification to the Reimschuessel model is introduced by considering both plasticization and anti-plasticization induced by water molecules. The proposed model is validated against the results of four different polymers obtained by Onogi et al., which demonstrates its capability of describing the available data. This model can be used to estimate the performance and service life of products produced using moisture-sensitive polymers. It also reveals that small amounts of diffused moisture might have a stiffening effect on the mechanical properties of hydrophilic polymers.     

上海市力学学会60年

上海市力学学会成立于1959年9月20日，到今年正好是一个甲子．60个春秋真实写照了上海市力学学会的建立、成长、发展与壮大的过程．60年来，在上海市科协的领导和中国力学学会的指导下，在各团体成员单位的大力支持下，上海市力学学会一代代力学工作者薪火相传、开拓耕耘，历届理事会及下属工作委员会和专业委员会团结奋进、不断创新，广大会员踊跃参与，为上海力学大力发展、力学人才精心培养、力学知识科学普及、力学服务国家发展战略和区域经济建设中做出了重要贡献，学会持续发展壮大．在庆祝力学学会成立六十周年之际，让我们共同抒怀上海力学六十年薪火相传、回顾近10年重要发展，展望上海力学新时代．     

An experimental investigation into non-linear wave loading on horizontal axis tidal turbines

Tidal turbines are subject to large hydrodynamic loads from combinations of currents and waves, which contribute significantly to fatigue, extreme loading and power flow requirements. Physical model testing enables these loads and power fluctuations to be assessed and understood in a controlled and repeatable environment. In this work, a 1:15 scale tidal turbine model is utilised to further the fundamental understanding of the influence of waves on tidal turbines. A wide range of regular waves are generated in both following-current and opposing-current conditions. Wave frequencies range from 0.31 Hz to 0.55 Hz & wave heights from 0.025 m to 0.37 m in a fixed 0.81 m/s current velocity. Waves are selected and programmed specifically to facilitate frequency domain analysis, and techniques are employed to isolate the effect of non-linear waves on turbine power and thrust.Results demonstrate that wave action induces large variations in turbine power and thrust compared to current only conditions. For the range of conditions tested, peak values of thrust and power exceed current-only values by between 7%–65% and 13%–160% respectively. These wave-induced fluctuations are shown to increase with wave amplitude and decrease with wave frequency. Following wave conditions exhibit greater variations than opposing for waves with the same wave height and frequency due to the lower associated wavenumbers.A model is developed and presented to aid the understanding of the high-order harmonic response of the turbine to waves, which is further demonstrated using steady state coefficients under assumptions of pseudo-stationarity. This approach is proven to be effective at estimating wave-induced power and thrust fluctuations for the combinations of waves, currents and turbine state tested. The outcome of which shows promise as a rapid design tool that can evaluate the effect of site-specific wave–current conditions on turbine performance.     

A STUDY OF LOW CYCLE FATIGUE PROPERTIES OF MATERIALS BASED ON THE FUNNEL-SHEET SPECIMENS1)

根据能量等效方法,针对漏斗薄片试样,提出了关联Ramberg-Osgood 幂律参数、试样几何参数的载荷-位移半解析统一模型。采用有限元数值模拟,正、反向验证了该模型的有效性。在此基础上,提出了通过漏斗薄片试样低循环试验实现材料低周疲劳性能的预测方法。基于薄片试样低循环试验数据,完成了SS316L, N18及SAPH440 三种材料的低周疲劳性能预测,预测结果与标准试样试验结果具有良好的一致性。并利用该方法完成了N18与SAPH在不同温度条件下的低周疲劳性能预测。